Non-destructive testing of steel tubes - Automated full peripheral ultrasonic testing of seamless and welded (except submerged arc-welded) steel tubes for the detection of longitudinal and/or transverse imperfections Ingestion-build-48024 PD IEC/TS 62556 is intended

PD IEC/TS 62556 is intended to support the ultrasonic measurement requirements given in IEC 60601-2-62

Where inspection for other types of defects is required

BS EN 50476 applies to short wave broadcast transmitters operating in the frequency range of 3 MHz to 30 MHz

high value or complex contracts

This part of ISO 5167 is applicable only to a flow which remains subsonic throughout the measuring section and where the fluid can be considered as single phase

Non-destructive testing of steel tubes - Automated full peripheral ultrasonic testing of seamless and welded (except submerged arc-welded) steel tubes for the detection of longitudinal and/or transverse imperfections Ingestion-build-48024 PD IEC/TS 62556 is intended1 Scope This part of ISO 10893 specifies requirements for automated full peripheral ultrasonic shear wave (generated by conventional or phased array technique) testing of seamless and welded [except submerged arc welded (SAW)] steel tubes, for the detection of longitudinal and or transverse imperfections. Unless otherwise specified in the purchase order, the testing method is applicable to the detection of predominantly longitudinal imperfections. In